Propagation Blog #1 – TOTES
By LaVille Logan
I think it is important to do a job with the best tools. One of my best tools is a clear plastic tote. The ones I use will hold 12 4”pots. When I make cuttings, they do better if they are in high humidity for a period of time. I place the cuttings in small cups (Blog #2 Containers and Medium) using a variety of mediums, and I arrange the already watered plants closely in said tote. The clear plastic of the sides and top allow bright indirect light to reach plants. The next day, and every day, I check to see if moisture had accumulated on the inside surface of the tote. If so, great. If not, I didn’t get the cuttings moist enough. They should be WET when placed in tote. You will not have to water them again for at least 2 weeks, perhaps a month if the lid is snapped on tightly. If the droplets of water that gather are large enough to “wander around” on the inside of the lid, perhaps there is too much humidity, and you can set the lid a little crooked on the tote to allow a little evaporation. House plants generally can use more humidity than outdoor plants. I check my totes daily, feeling the air inside to make sure it is not too hot. Any direct sun on a tote may create a solar oven, so be careful. The very low winter sun provides just the right amount of light and heat to keep cuttings safe from low temperatures. However, when we had a streak of very low night temps (anything below 40 for several days) I brought them all inside. I have learned a few plants don’t like humidity and will turn black and fuzzy after the initial root development (about three to four weeks) while others may be fine with it. Just keep an eye on them daily and move plants that are not thriving to a protected place out of the closed tote. If you do not want to “dive in” and purchase large totes, you can create a humid environment around a pot containing cuttings by covering it with a large Ziploc plastic bag.